Optional digital unit, UT-118
The optional UT-118 provides D-STAR format digital voice and slow data communication. The UT-118 includes the following digital features.

Callsign calling
In the digital mode, your callsign and the receiving callsign (or CQ message) are included in each transmission. The callsign squelch allows you to choose an incoming call selected by the callsign. Also, received callsigns are automatically stored in the memory.

Position exchange with external GPS receiver
When connected to an external GPS receiver*, position information can be exchanged with other stations. When the receiving side is connected to a PC**, position monitoring is possible.
* NMEA 0183 output and RS-232C interface are required.
** Position mapping software required (Not supplied by Icom ).

And more digital features
20-character short data message
Digital code squelch
EMR communication
Digital pocket beep
Stand-by beep

7W powerful output power
A powerful 7W* output power provides superior transmit power. All this power is available with the supplied battery pack. Reduced power settings also allow you to adapt to the communication conditions and provide longer operating time.
* 5W for UHF.

200 memory channels and 10 memory banks
Up to 200 regular memory channels can be stored with a 6-character channel name, tone and duplex settings. The memory channels can be tagged with A-J bank name and allows you easy channel management. In addition, use Icom’s exclusive DMS (Dynamic Memory Scan) system to scan selected memory banks by simply adding and deleting bank links.

Built-in CTCSS/DTCS
Built-in CTCSS/DTCS tone codes provide quiet stand-by and allowyou to access a closed repeater. The pocket beep alerts you when a matched tone frequency is received. The tone scan detects the tone frequency used in the receiving frequency.

CTCSS and DTCS Operation Standard
50 CTCSS and 104? DTCS tone squelch operation codes (encode and decode) provide quiet standby and allow you repeater access. A pocket beep alerts you of a call and a tone scan can detect the sub-audible tone in use in the receiving signals.

Standard DTMF Encoder and Optional DTMF Decoder
5 DTMF memory channels with up to 24 DTMF codes allow remote operation. The optional UT-108 DTMF decoder unit provides code squelch operation as well as a pager function.

Other features

NOAA weather channel receive * (* IC-V82 USA version only)
Automatic repeater function (USA version only)
Reversible control knob and up/down buttons assignment
Durable construction and simple operation
16 DTMF dial memory
PC cloning capability

--------------------------------------------------------------------------------
SPECIFICATIONS

GENERAL

Version	IC-V82	IC-U82
USA	Tx144-148 MHz Rx 136-174 MHz *Guaranteed range 144-148MHz	Tx 420-450 MHz Rx 400-479 MHz *Guaranteed range 440-450MHz
Europe	144-148 MHz	Tx 430-440 MHz

Mode : F3E, F2D, F7W
Number of memory ch. : 207 (6 scan edges, 1 call)
Antenna connector : BNC (50 ohm)
Power supply : 7.2 V DC (6.0 —10.3V DC acceptable, Icom's battery pack only)
Frequency stability : ± 2.5 ppm -10° C to +60° C

Current drain (at 7.2 V DC) :

		IC-V82	IC-U82
Tx	High(7W/5W)	2.6A	2.0A
Rx	Max.Audio	250mA	250mA
	Standby	80mA	80mA
	Power save	30mA	30mA

Usable temp. range : -10° C to + 60° C ; + 14°F to +140°F
Dimensions
(projections not included) : 54(W) ×139(H) ×36.7(D) mm
21/8(W) ×515/32(H) ×17/16(D)in.
Weight : 390g; 13.8oz (with BP-222N)

TRANSMITTER
Output power (at 7.2 V DC)

	IC-V82	IC-U82
High	7.0W	5.0W
Mid	4.0W	2.0W
Low	0.5W	0.5W

Spurious emissions : Less than -60 dB
Max. freq. deviation : ± 5KHz/ ± 2.5KHz (Wide/Narrow)
Ext. MIC connector : 3-conductor 2.5(d) mm (1/10")/2.2k ohm

RECEIVER
Receive system : Double-conversion super heterodyne
Intermediate frequencies : 1st 46.35 MHz / 2nd 450 kHz

Sensitivity (at 12dB SINAD) : 0.16 µV typ.
Squelch sensitivity (at threshold) : 0.11µV typ.
Selectivity : more than 55/50dB (Wide/Narrow) typ.
Inter modulation : 65dB type.
Spurious and Image rejection : 80dB (typ.; VHF), 70dB (typ.; UHF)
Audio output power : 300 mW typ. with an 8 ohm load
Ext SP connector : 3-connector 3.5 (d) mm (1/8")/8 ohm
Exp Data connector : 3-connector 2.5 (d) mm(1/10")

Supplied accessories:
- Antenna
- Belt clip
- Desktop charger*
- Battery case or battery pack*
*Depending on version
All stated specifications are subject to change without notice or obligation.
--------------------------------------------------------------------------------
OPTIONS

- BATTERY CASE AND BATTERY PACKS

MODEL		BP-208N	BP-209N	BP-210N	BP-211N	BP-222N
Type		6×AA(LR6)	Ni-cd	Ni-MH	Li-Ion	Ni-cd
V/Ah			7.2V/1100mAh	7.2V/1650mAh	7.4V/1800mAh	7.2V/600mAh
Battery Life	VHF(7W)	/	3 h 20 min	6 h	6 h 10 min	2 h 15 min
	UHF(5W)	/	3 h 40 min	7 h	8 h 15 min	2 h 50 min

- Battery life is approx. time.; Tx (Hi): Rx: standby=1:1:8 power save function when set at auto

- BC-146 + BC-147A/E DESKTOP CHARGER + AC ADAPTER
Charges the battery pack, BP-209N, BP-210N or BP-222N with/without transceiver in 12, 18.5, 6.5 hours (approx.), respectively. The BC-147 AC ADAPTER is additionally required. Cannot charge Li-Ion battery pack, BP-211N.

- BC-144N + BC-145A/E/V DESKTOP CHARGER + AC ADAPTER
For rapid charging of battery pack, BP-209N, BP-210N or BP-222N. An AC adapter, BC-145, is supplied with the charger depending on version. Cannot charge Li-Ion battery pack, BP-211N. Charging time: 1.5 to 2 hours. BC-119 is also available for rapid charging.

- BC-121 + AD-101 + BC-124 DESKTOP CHARGER + DESKTOP CHARGER ADAPTER + AC ADAPTER
For rapid charging of up to 6 battery packs (including BP-211N). An AC adapter, BC-124, may be supplied, depending on version. Charging time: 1.5 to 2 hours. Six AD-101s are required.

- HM-75A/HM-131L/HM-128L SPEAKER-MICROPHONES
- HM-75A: Allows you to remotely select operating channels, etc., according to cloning.
- HM-131L: Compact and durable body. Equipped with an earphone jack and a revolving clip.
- HM-128L: Lightweight earphone-microphone.

- HS-94/HS-95/HS-97 + VS-1L EARHOOK-HEADSET + VOX/PTT CASE
- HM-94: Earhook headset with flexible boom microphone.
- HM-95: Behind-the-head headset with flexible boom microphone.
- HM-97: Throat microphone fits around your neck and picks up speech vibration.

- MB-86/103 BELT CLIP
- MB-86: Alligator type clip. Same as supplied.
- MB-103: Swivel belt clip.

- UT-108 DTMF DECODER
Provides DTMF decode capability with code squelch and pager operation.

- UT-114 / 118 DIGITAL UNITS
- UT-114: With voice scrambler.
- UT-118: Without voice scrambler.

- CS-V82 + OPC-478/U CLONING SOFTWARE + CLONING CABLE
Provides quick and easy programming of memory channel, names, etc. OPC-478U is USB cable type.

- OPC-474 CLONING CABLE
Used for handheld-to-handheld data cloning.

- SP-13 EARPHONE
Provides clear audio in noisy environments.